"The Fleur" - Fine
This little one is part of our Miniature range.
It may look small but believe me it is mighty! It's of dentistry grade which means its super refined and it will remove dead protein you didn't even know existed!
It's super popular for its super narrow shape. It can be used as a step 1 piece to separate the cuticle from the nail plate or as a step 3, for reaching the difficult areas at the end of your prep routine.
- Diamond Bit
- 100% Tungsten Steel
- Cuticle Bit
- Mini pointer shape
- Fine Grade
- Suitable for Manicure & Pedicure
- Step 1 or 3 piece
- Perfect for separating the skin from the nail plate and getting to those hard to reach areas
- Standard shaft width of 3/32"
- Fits all E-file Machines
The Willow Range is compiled of our best pieces to make your job more effective, cost efficient and easier on your body as well as your pocket.
The bit must be cleaned periodically to remain sharp by following the manufacturer's instructions. Drill bits usually last 2-3 months but this can vary dependent on how busy you are.
AFTERCARE & CLEANING:
- Use warm soapy water, our Spit-Spot-Bit-Pot and our Willow Brass Brush to remove the dust and product debris from within the grits, flutes and teeth.
- Do not allow the bit to air dry!
- Once the bit is fully clean and dry you can use your preferred sterilising method.
- We recommend our "Willow Spray & Go" system as the less time your bits spend immersed in solution, the better!
- Lay your E-file bits on a towel and evenly spray the Spray & Go over all of the bits.
- Roll the bits over and spray evenly again.
- If soaking in barbicide please only steep for the recommended time, over-steeping can dull your drill bits.
- Wait 2 mins and then dry all of your bits thoroughly by hand (do not leave to air dry)
- Store in your bit case or bit book.
"The Fleur" - Fine