The No-Soak Kit – Rubber Base Coat (Speciality Carbides)
The No-Soak Kit has been developed for professionals working with rubber base coats as part of The No-Soak Method. This version features two of our most powerful speciality carbide bits, best for systems with rubber bases.
Inside this kit you’ll find:
Together, they deliver everything you need for effective removal of colour on top of Rubber base.
Details
-
The Green Smoothie - Coarse - Spiral Cut - Safety top
-
The 5 in 1 - Coarse (F,M,C)
- Speciality Carbides
-
Safety tops for confident work
-
Right-handed & left-handed compatible
-
100% Tungsten Steel
-
Standard shaft width of 3/32" – fits all e-file machines
- Recommended Speeds 20-25rpm
Life Span
E-file bits must be cleaned & stored correctly to remain sharp. Always follow the manufacturer’s instructions.
Recommended Cleaning
Step 1
Remove dust and product using warm soapy water, the Willow Spit-Spot-Bit-Pot, and our Brass Brush. Alternatively, place in your Ultrasonic Cleaner with suitable detergent on the relevant cycle.
Step 2
Disinfect or sterilise. We recommend the Willow Spray & Go 2-in-1 system as it avoids prolonged soaking. Spray evenly, roll, and spray again. If using a soaking system, only steep for the recommended time — over-soaking will dull your bits.
Step 3
Wait 2 minutes, then thoroughly dry by hand (do not leave to air dry). Store in your Bit Case or Bit Book.
When to Replace Your Bit
If your bit once required 1–2 swipes but now takes 3+ to penetrate product, it’s time for a new piece. Continuing to use a worn bit slows removal and increases physical strain.
