The No-Soak Kit – Thin Viscosity Base Coat (Speciality Carbides)

The No-Soak Kit – Thin Viscosity Base Coat (Speciality Carbides)

The No-Soak Kit has been designed to support professionals embracing The No-Soak Method with the very best tools. This version is tailored for thin viscosity base coats and features two of our most advanced speciality carbide bits.

Inside this kit you’ll find:

• The 5-in-1 – Fine Grade, Purple (Fine at the tip, Medium on the belly & Coarse at the base. 

• The Opal – Extra Fine, Black

These pieces are Speciality Carbides with a combination of straight cut & Spiral Cut flute formations. They are designed to remove layer by layer.

This kit is perfect for techs who prefer speciality carbide designs for their superior adaptability and refined control.

Details

• Fine & Extra Fine Grade options

• Speciality Carbide designs for thin viscosity base coats

• 5-in-1 Fine - (F,M,C) Straight Cut

• Opal extra fine - Spiral Cut

• Safety tops for confident, close- up work

• Right-handed & left-handed compatible

• 100% Tungsten Steel

• Standard shaft width of 3/32" – fits all e-file machines

• Recommended Speeds 20-25rpm

Life Span

• Purple– Coated in Nickel (4-6 months with correct care)

• Black– Coated in Nickel (8 months plus, with correct care)

E-file bits must be cleaned & stored correctly to remain sharp. Always follow the manufacturer’s instructions.

Recommended Cleaning

Step 1
Remove dust and product using warm soapy water, the Willow Spit-Spot-Bit-Pot, and our Brass Brush. Alternatively, place in your Ultrasonic Cleaner with suitable detergent on the relevant cycle.

Step 2
Disinfect or sterilise. We recommend the Willow Spray & Go 2-in-1 system as it avoids prolonged soaking. Spray evenly, roll, and spray again. If using a soaking system, only steep for the recommended time — over-soaking will dull your bits.

Step 3
Wait 2 minutes, then thoroughly dry by hand (do not leave to air dry). Store in your Bit Case or Bit Book.

When to Replace Your Bit

If your bit once required 1–2 swipes but now takes 3+ to penetrate product, it’s time for a new piece. Continuing to use a worn bit slows removal and increases physical strain.