"The Super Mini 5 in 1" Bit - Extra Fine

"The Super Mini 5 in 1" - BRAND NEW - YOU HAVE SEEN IT HERE FIRST. 

(it's even smaller)

If you struggle, we will come up with a solution.

Our best seller but it's super mini & Super fine for refining. 

But do not be fooled, it is mini but mighty!

This is absolutely perfect for those who find it difficult to manoeuvre the full length of a bit. It is important to use the whole bit evenly, that means using the tip, the belly and the very inner section of the piece. Many find this difficult as the position can feel quite awkward and therefore do not get to use the last grit & in turn wear out the bit faster. 

The Super Mini 5 in 1 means you can access all areas easily and efficiently. 

How does it have 5 benefits in one?

It has three grades in one bit, and it is a safety bit with an R-cut top tooth.  It is also a two-way piece, meaning it works in forward and reverse for left-handed and right-handed tech!

The Grit:

• Tip - Extra, Extra, Extra Fine
• Belly - Extra, Extra Fine
• Base - Extra Fine 

"The Super Mini 5 in 1" -Extra Fine

• Safety Bit (R-cut)
• Speciality Carbide 
• Two-way use 
• 5.2mm head 
• Fits all E-file machines 
• 3/32" standard shaft width
• Right-handed & left-handed
• Perfect for removals of this gel polish without rubber base but best for refining product

Each bit must be cleaned to remain sharp by following the manufacturer's instructions. Drill bits usually last 2-3 months but this can vary dependent on how busy you are. 

AFTERCARE & CLEANING: 

• Using your Spit-spot-bit-pot, warm soapy water and the Willow Brass Brush to remove the dust and product debris from within the grit's flutes and teeth. 
• Once the bit is fully clean you can use your preferred sterilising method. 
• We recommend that you dry your pieces thoroughly and then lay them out on a towel 
• Then spray evenly with "Willow Spray & Go" and leave for 2 minutes
• Dry thoroughly and then you ready to go!
• If soaking in Barbicide please only steep for the recommended time only, over-steeping can dull your drill bits making sure that the solution is correctly measured. 
• Once sterilised, dry the pieces and store in your Willow Container or Bit book
• Alternatively, after cleaning your pieces with warm soapy water you can use a UV sterilising cabinet or an Autoclave. 

How do I know I need a new E-file bit? 

If the bit you are using originally took 1-2 swipes along the nail to penetrate the product and now is taking 2,3+ swipes to penetrate, the product it's now time for a new bit. You may also be taking longer, or you may be starting to feel more body wear and tear because you are having to work harder to penetrate the product.